|
Disassembly Instructions
Assembly Instructions- Spirol Lock Style
| Step 1: Hold the bottom (lower) spirol lok ring in your right hand with the bottom end to your left. |
 |
| Step 2: Insert the very bottom END of the spirol lok into the slot in the housing. |
 |
| Step 3: With your right thumb on the top side of that bottom ring and your forefinger under that bottom ring, tip the top of the spirol lok toward you (like a cup of coffee) while pushing the spirol lok down into the slot in the housing. Do not try to thread or spin the spirol lok in, the key is the tipping motion of your right hand while pushing down to get it to snap in. |
 |
| Step 4: Continue this technique until the spirol lok is completely installed into the slot in the housing. |
 |
| Step 5: The filter element will normally be a little loose in the housing. As the filter tightens on the engine it will tighten against the spirol lok which will eliminate any play. |
 |
Disassembly Instructions - Spirol Lock Style
| Step 1: Use a small screwdriver to gently pry up the top end of the metal spirol lok that holds the filter in the case. |
 |
| Step 2: Use caution not to damage the rubber quad-ring that seals the top of the filter to the engine (it can be removed if you like. |
 |
| Step 3: Pull the spirol lok up and toward the center of the filter in a circular motion and work the spirol lok out of its slot. you should now be able to remove the filter element from the case. |
 |
|